PART OF CATALOG

ER-Precision collet chuck BT 30 – 2/20 – 70 | ER 32

€95.00

Application:
For mounting straight-shank tools in 2 µm-collets.


Advantage:

  • Excellent concentricity in the system (chuck + collet + clamping nut)
  • 3 µm radial run-out with a 2 µm clamping nut, 6 µm radial run-out with a 5 µm clamping nut
  • Extremely strong holding force (increases the holding power by at least 60% compared to standard ER chuck)
  • Plain clamping nut without grooves for high speed machining

 

ER-Collet with cooling channel holes ER25 | 430EC | < 15µm | O 8

€42.00

Application:
For mounting straight-shank tools in collet chucks DIN 6499.


Note:
Only nominal size d can be clamped, with cooling channels. In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet. (applicable up to 21 bar)

ER-Precision collet | stainless steel ER11 | 4008ESP | < 5 µm | O 5,5 - 5,0

€39.00

- Rustproof
- Stainless steel 1.4021 x 20Cr13
- HRC 43-47
- Longer-lived than standard collets
- Higher repeat-accuracy
- Maximum concentricity <0,005mm
- Honed collet boring
- Especially suitable fore wire EDM

Digital Caliper | 0-200mm for outside grooves / with data output

€173.00

Construction:

  • Resolution: .0005" / 0.01mm
  • Measures external groves and recessed hub dimensions
  • Inch/Metric conversion
  • Zero-setting at any position for incremental measurement

Delivery:

  • Warranty card
  • Instruction manual
  • Calibration certificate
  • CR2032 3,0V Battery

Tapping chucks for synchronisation BT 50 – M3-M16 – 100 | ER 20

€319.00

Application:
For machining centres with synchronous spindle.


Note:

  • Synchro tapping chucks compensate synchronisation errors.
  • Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap, which can cause high frictional forces on the thread flanks.
  • A possible increase of axial force during the tapping process is reduced to a minimum.
  • Suitable for internal coolant.
  • Coolant pressure up to max. 100 bar.

Delivery:
With balanced clamping nut


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

FREE CONSULTATION

Have questions?
Leave a request