Shrink chuck 3° SK 40 – 03 – 80
Application:
For mounting tools with straight shanks.
Version:
slim design (reduced interference contour)
Note:
Toolholders suitable for induction-, contact- and hot air shrink units.
For O 3, 4 and 5 mm only solid carbide tool shanks must be used.
O 3, 4, 5 with h4-tolerance and O 6 O 32 with h6-tolerance.
HSSE twist drill 135° 11,9 mm DIN 338 | TIN coating
Shrink chuck 4,5° SK 50 – 10 – 120
Application:
For mounting tools with straight shanks.
Note:
Toolholders suitable for induction-, contact- and hot air shrink units. O 3, 4, 5 with h4-tolerance and O 6 O 32 with h6-tolerance
For O 3, 4 and 5 mm only solid carbide tool shanks must be used!
- All holders are made of forged steel
- Specific, low warpage hardened
- Surface hardened HRC 58~60
- Hardening depth 0,8mm~0,9mm
- Taper angle tolerance < AT 3 according to DIN 2080
- Surface roughness Ra < 0,4 µm
- Tensile strength in the core of min. 800 N/mm? after DIN
- All functional surfaces fine machined
HSSE twist drill 135° 13,0 mm DIN 338 | TIN coating
ER-Collet with seal for IC ER20 | 428EH | < 15µm | O 13
Shrink chuck 4,5° SK 40 – 14 – 80
Application:
For mounting tools with straight shanks.
Note:
Toolholders suitable for induction-, contact- and hot air shrink units. O 3, 4, 5 with h4-tolerance and O 6 O 32 with h6-tolerance
For O 3, 4 and 5 mm only solid carbide tool shanks must be used!
- All holders are made of forged steel
- Specific, low warpage hardened
- Surface hardened HRC 58~60
- Hardening depth 0,8mm~0,9mm
- Taper angle tolerance < AT 3 according to DIN 2080
- Surface roughness Ra < 0,4 µm
- Tensile strength in the core of min. 800 N/mm? after DIN
- All functional surfaces fine machined
Have questions?
Leave a request
OUR PARTNERS
