PART OF CATALOG

Morse taper adaptor HSK 63 – 4 – 160

132.00

Application:
For clamping tools with Morse taper shank and thread according to DIN 228-1 form A.


Delivery:
With built-in tightening bolt


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

Shell mill holder BT 40 – 27 – 160

111.00

Application:
For mounting milling cutters with transversal groove.


Note:
d = 40/d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079.


SK 30 without coolant exit bores on the end face

Delivery:
With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912.


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

Solid carbide 3 flutes long 12mm 12,0 – 12 AlTiCrN coating

56.00

Application:
Coating: AlTiCrN, Excellent high-performance end mills, for processing material < 48HRC, for weldon shanks according to DIN 6535 HB.

Shrink chuck 4,5° SK 40 – 12 – 160

182.00

Application:
For mounting tools with straight shanks.


Note:
Toolholders suitable for induction-, contact- and hot air shrink units. O 3, 4, 5 with h4-tolerance and O 6 – O 32 with h6-tolerance1


For O 3, 4 and 5 mm only solid carbide tool shanks must be used!
  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

Ring gauge “NO GO” M42 | 6g ISO-metric thread | DIN 13

104.00

Construction:

  • Hardened steel
  • ISO-Metric Thread
  • DIN 13
  • 6g

Delivery:
Calibration certificate

ER-Collet with seal for IC ER40 | 472EA | < 15µm | O 23

51.00

Application:
Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system


Note:
Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet.

FREE CONSULTATION

Have questions?
Leave a request