PART OF CATALOG

ER-Precision collet | stainless steel ER20 | 428ESP | < 5 µm | O 7,5 - 7,0

41.00

- Rustproof
- Stainless steel 1.4021 x 20Cr13
- HRC 43-47
- Longer-lived than standard collets
- Higher repeat-accuracy
- Maximum concentricity <0,005mm
- Honed collet boring
- Especially suitable fore wire EDM

ER-Collet with seal for IC ER40 | 472EH | < 15µm | O 15

58.00

Application:
Collets sealed for high pressure cooling 120 bar with IC DIN 6499 B (ISO 15488 B) ER-system


Note:
Only nominal size d can be clamped (applicable up to 120 bar). In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet.

End mill holder Weldon with cooling channels HSK 63 – 32 – 110

144.00

Application:
For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon).


Delivery:
With clamping screw and O-ring


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

Quick change tapping chuck PSK 50 – M5-M22 – Gr. 2

798.00

Application:
For the chucking of quick change adaptors for taps.



  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

Combi shell mill holder MK 4 – 22 – 55

101.00

Application:
For mounting milling cutters with transverse or longitudinal groove.


Delivery:
With retaining screw, driving ring and feather key

End mill holder Weldon SK 40 – 16 – 160

81.00

Application:
For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon).


Delivery:
With clamping screw


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

FREE CONSULTATION

Have questions?
Leave a request