PART OF CATALOG

Shell mill holder PSK 50 – 16 – 35

235.00

Application:
For mounting milling cutters with transversal groove.


Note:
d = 40/d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079.


Delivery:
With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912.


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

ER-Collet chuck MK 2 – 1/10 – 45 | ER 16

105.00

Application:
For mounting straight-shank tools in collets.

With balanced clamping nut

HSS-E spiral flute taps fine thread M10 7×5,5 P=0,75 DIN 374

22.00

Application:

  1. Thread configuration with a special design, prevents overfeeding, thin thread and pitch diameter oversize.
  2. Flute geometry with special design, better chip evacuation, prevents chip clogging, improves thread quality
  3. Excellent performance on various work material: Stainless steel, carbon steel, alloyed steel, tool steel

ER-Collet with cooling channel holes ER40 | 472EC | < 15µm | O 4

53.00

Application:
For mounting straight-shank tools in collet chucks DIN 6499.


Note:
Only nominal size d can be clamped, with cooling channels. In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet. (applicable up to 21 bar)

ER-Gewindebohrer-Spannzange IK ER32 | 470GA | < 15µm | 12 x 9

46.00

Application:
For machines with rigid tapping. For safe clamping of taps. Collets sealed with seal for IC.

Quick change adaptors with safety clutch Size 3 | M33 | 25 x 20 | DIN 376

104.00

Application:
For mounting taps. For right-hand and left-hand threads. Type with adjustable safety clutch, which prevents the breaking of taps.


Note:
Quick change adaptors with safety clutch are supplied with a predefi ned torque, corresponding to the sizes of the threads.

Quick change adaptors without safety clutch Size 2 | 10 x 8

24.00

Application:
For mounting taps. For right-hand and left-hand threads. Standard type without safety clutch.


Note:
Quick change adaptors without safety clutch can be interchanged, because only the shaft diameters and the squares must fit.

FREE CONSULTATION

Have questions?
Leave a request