PART OF CATALOG
Quick change adaptors with safety clutch Size 1 | M10 | 10 x 8 | DIN 371
ER-Collet ER32 | 470E | < 15µm | O 17 - 16
ER-Collet with seal for IC ER40 | 472EA | < 15µm | O 25
Application:
Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system
Note:
Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet.
ER-Gewindebohrer-Spannzange IK ER16 | 426GA | < 15µm | 4,5 x 3,4
Micrometer | analogue | 75 – 100 reading 0,01mm
Pull studs ISO 7388-3 | Form UD | M24 | with drill through | without O-ring
Shrink chuck 4,5° HSK 63 – 03 – 120
Application:
For mounting tools with straight shanks.
Note:
Toolholders suitable for induction-, contact- and hot air shrink units. O 3, 4, 5 with h4-tolerance and O 6 O 32 with h6-tolerance
For O 3, 4 and 5 mm only solid carbide tool shanks must be used!
- All holders are made of forged steel
- Specific, low warpage hardened
- Surface hardened HRC 58~60
- Hardening depth 0,8mm~0,9mm
- Taper angle tolerance < AT 3 according to DIN 2080
- Surface roughness Ra < 0,4 µm
- Tensile strength in the core of min. 800 N/mm? after DIN
- All functional surfaces fine machined
FREE CONSULTATION
Have questions?
Leave a request
OUR PARTNERS
