PART OF CATALOG

Milling arbors for screw-in cutters SK 50 – M12 – 69 – LB50

132.00

Application:
For mounting screw-in cutters with thread.


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

Clamping sleeves for taps with quick change DCONMS=32 | 16 x 12

60.00

Application:
For machines with rigid tapping. For safe clamping of taps in end mill holders according to DIN 1835 B.

Morse taper adaptor SK 50 – 1 – 45

96.00

Application:
For clamping tools with Morse taper shank and thread according to DIN 228-1 form A.

With built-in tightening bolt


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

ER-Precision collet | stainless steel ER32 | 470ESP | < 5 µm | O 12,0 - 11,5

44.00

- Rustproof
- Stainless steel 1.4021 x 20Cr13
- HRC 43-47
- Longer-lived than standard collets
- Higher repeat-accuracy
- Maximum concentricity <0,005mm
- Honed collet boring
- Especially suitable fore wire EDM

Key for coolant tube HSK 100

24.00

Application:
For mounting the coolant tubes in HSK toolholders.


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

End mill holder Weldon HSK 32 – 12 – 70

109.00

Application:
For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon).


Delivery:
With clamping screw


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined
FREE CONSULTATION

Have questions?
Leave a request