PART OF CATALOG
Milling arbors for screw-in cutters BT 40 – M10 – 77 – LB50
Application:
For mounting screw-in cutters with thread.
- All holders are made of forged steel
- Specific, low warpage hardened
- Surface hardened HRC 58~60
- Hardening depth 0,8mm~0,9mm
- Taper angle tolerance < AT 3 according to DIN 2080
- Surface roughness Ra < 0,4 µm
- Tensile strength in the core of min. 800 N/mm? after DIN
- All functional surfaces fine machined
Rectangular gauge block set | 87 pieces Grade 2 | (ISO / DIN / JIS /GB)
Swivel base for machine vice HP-60 / MP-60
Quick change adaptors without safety clutch Size 2 | 9 x 7
Morse taper adaptor – form F1 F1 – 30 – MK3
ER-Collet with seal for IC ER20 | 428EA | < 15µm | O 12
Application:
Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system
Note:
Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet.
FREE CONSULTATION
Have questions?
Leave a request
OUR PARTNERS
