PART OF CATALOG

High Performance Milling Chuck BT 50-32-90 JIS B 6339 (MAS-BT) AD/B HKS-system in wooden box

618.00

Application:
For mounting straight-shank tools.


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

Precision vice AVQ-200G/HV mechanical with mechanical booster

2,638.00

Construction:
- With mechanical booster - Clamping force preadjustable by graduation lines
- Clamping positions: horizontal, vertical and lateral
- The steel body is hardened and grinded all-round
- Integrated pull-down mechanism
- Bed height H: 0,01 mm


Delivery:

  • Instructions for use
  • Wrench
  • 4 pcs. vice clamps
  • 4 pcs. T-nuts 18 mm
  • Test certificate

Collets set | 5 µm | ER32 | stainless steel 470 ESP |

729.00

- Rustproof
- Stainless steel 1.4021 x 20Cr13
- HRC 43-47
- Longer-lived than standard collets
- Higher repeat-accuracy
- Maximum concentricity <0,005mm
- Honed collet boring
- Especially suitable fore wire EDM

Vernier caliper | 0-150mm analogue | with thumb clamp | O 1,8mm

48.00

Construction:

  • Measuring surfaces allow for the measurement of external diameters, internal diameters, depths and steps
  • Stainless steel with surface hardened measuring faces

Delivery:

  • Warranty card
  • Instruction manual
  • Calibration certificate

End mill holder Whistle-Notch BT 40 – 16 – 63

55.00

Application:
For mounting straight-shank tools and inclined flat according to DIN 1835 form E (Whistle Notch).


Delivery:
With clamping screw and axial adjustment bolt


  • All holders are made of forged steel
  • Specific, low warpage hardened
  • Surface hardened HRC 58~60
  • Hardening depth 0,8mm~0,9mm
  • Taper angle tolerance < AT 3 according to DIN 2080
  • Surface roughness Ra < 0,4 µm
  • Tensile strength in the core of min. 800 N/mm? after DIN
  • All functional surfaces fine machined

 

 

Solid carbide 3 flutes short 8mm 8,0 – 8 AlTiCrN coating

25.00

Application:
Coating: AlTiCrN, Excellent high-performance end mills, for processing material < 48HRC, for weldon shanks according to DIN 6535 HB.

ER-Precision collet chuck SK 50 – 2/20 – 100 | ER 32

140.00

Application:
For mounting straight-shank tools in 2 µm-collets.


Advantage:

  • Excellent concentricity in the system (chuck + collet + clamping nut)
  • 3 µm radial run-out with a 2 µm clamping nut, 6 µm radial run-out with a 5 µm clamping nut
  • Extremely strong holding force (increases the holding power by at least 60% compared to standard ER chuck)
  • Plain clamping nut without grooves for high speed machining

 

FREE CONSULTATION

Have questions?
Leave a request